Jun-Air professional air compressor for Pneumatic Heat Transfer Press, TheMagicTouch Transfer Media Printing System

Professional compressor to comply with heat transfer press with pneumatic operation.

Tank size: 24 L./6.34 US Gall.
Power: 230 V/50 Hz
Maximum Pressure: 8 bar/120 PSI
Weight: 25.2 kg/55.6 lbs

Remove the packaging and make sure that the compressor has not been damaged during transportation.
Always keep the compressor in a vertical position during use and transportation. Protect the compressor agianst rain, moisture, frost and dust and keep it out of reach of children.
Caution: Do no operate the compressor at ambient temperatures exceeding 35^oC/95^oF as this may cause overheating. Ensure that adequate ventilation is available during operation.
Replace the yellow cap on the air intake tube with the intake filter.
Connect the plug.
Start the compressor using the ON/OFF switch on the pressure switch. The compressor will automatically switch off at the preset pressure. If the motor does not start it may be due to pressure in the receiver, and the motor will then start automatically when the pressure reduces to approx. 6 bar/87 PSI
Connect pneumatic equipment and the compressor is now ready for use.
Caution: The compressor oil may be aggressive towards certain gasket materials used in pneumatic equipment. We recommend Teflon, Viton, etc.. Do not use polycarbonate filter bowls.
Handling: Always keep the compressor in a vertical position as oil may run out of the intake filter. During transportation, mount the yellow cap on the inlet. Mechanical noise from the compressor in connection with handling does not have any functional importance.

Maintenance

Check oil level weekly. During standstill the correct level is between the maximum and minimum indications.
Check drain condensate from air receiver weekly. ( at a pressure of max. 2 bar/30PSI)